User's Manual

24 25
6.1 Reseng the Zones
Reseng the zone(s) on your receiver removes any
sensors that are paired to it, allowing you to re-pair those
sensors to a dierent zone. Reseng is also useful when
troubleshoong common issues.
To clear sensors from a zone:
6.2 Changing your Chime
To change your chime, follow the steps in secon 2.3,
“Pairing your Sensor and Receiver” with both your sensor
and your receiver nearby. If done correctly you will hear a
double-beep on your receiver conrming that a new melody
has been set.
Issue
Inconsistent
alarms
Cause
Incorrect
sensor
sengs
Mulple
receiver
conict
Low Baeries
Soluon
Reset all sensor dip
switches to factory sengs
(see Advanced Sengs)
Follow the steps below in
Mulple Receiver Conicts
to reset your pairing code
Replace your sensor
baeries and re-pair your
sensor to your receiver.
See Pairing the Sensors
with the Receiver for re-
pairing. Alkaline baeries
can be severely depleted in
cold temperatures.
We recommend using
lithium baeries in
your sensor to avoid
temperature-related issues
Issue
False
Alarms
Can’t
change
melody/
wrong
melody?
Sensor
doesn’t
stay where
pointed
Cause
Sensor or
Receiver
receiving
electrical
interference
Moisture
inside sensor
Low baeries
Sensor paired
with dierent
melody
Sensor swivel
screw too
loose
Soluon
Move sensor and/
or receiver away from
electrical transformers or
other cause of interference
Take sensor inside, remove
backplate and baeries,
and air dry for 24 hours,
then test it the following
day. When re-installing,
ensure backplate is
securely screwed on and
sensor is protected from
the elements
When the baeries in your
sensor or receiver are low,
it can cause your device
to behave erracally. See
Checking Baery Status to
determine baery health
Follow instrucons in
Changing your Chime to
resolve
Use a phillips head
screwdriver to ghten the
screw on the back of the
mounng plate
BEEP
1. Press and hold LEARN/NEXT
for 3 seconds to enter Learn
mode and select Zone 1
2. To select another zone, press
LEARN/NEXT
3. Press and hold PAUSE/RESET
for 3 seconds to unpair all sensors
in that zone. The receiver will
beep when the zone is unpaired
4. Repeat steps 2 and 3 to reset
addional zones; to exit Learn
Mode, turn the receiver o and
then on again
5. Any sensors that were unpaired
during this process will have to be
re-paired to your receiver in order
to receive alerts from them