User's Manual

22 23
Most issues that arise can easily be resolved by changing the
sengs on your Guardline Driveway Alarm or performing
a simple reset. Use the table below to nd your exact issue
and possible soluons for it.
Issue
No alarms
Cause
Sensor and/or
receiver not
turned on/
powered up
Volume not
turned up
Sensor not
paired with
receiver
Soluon
Conrm that your sensor
and receiver have working
baeries and/or are
plugged in and turned on.
Your receiver will have
a solid red or blue LED
above zone 1 when it is
powered on.
Your sensor eye will light
up red when it is
acvated
Ensure volume wheel on
the receiver is turned up
(turn towards 12V port for
max volume)
Follow instrucon in
Pairing the Sensors with
the Receiver
6. Troubleshoong
Issue
No alarms
Sensor eye
not lighng
up
Inconsistent
alarms
Cause
Incorrect
sensor
sengs
Sensor
baeries are
low, depleted
or not
installed
Sensor
not paired
properly
Sensor out
of range of
receiver/
interference
issue
Mulple
receiver
conict
Incorrect
sensor
sengs
Soluon
Reset all sensor dip
switches to factory sengs
(see Manufacturer Default
Sengs)
If your sensor is paired
with your receiver, look
at the LED below zone
3 on the receiver. If that
LED is lit or ashing, the
sensor baeries need to
be changed
Reset all zones on your
receiver and re-pair
your sensor(s). See
the “Reseng the
Zones” secon for reset
instrucons
If your sensor eye lights
up when acvated, but
you aren’t geng the
alarm on your receiver,
then your sensor is out
of range. If there is heavy
interference between
sensor and receiver,
your maximum eecve
range will be decreased.
Move sensor and receiver
closer together unl you
consistently receive alerts
Follow the steps below
in “Mulple Receiver
Conicts” to reset your
pairing code.
Reset all sensor dip
switches to factory sengs
(see Manufacturer Default
Sengs)
Signal
Interference
End of
funconal
range
Move sensor to new
locaon at least 5 feet
from metal gates, poles
or structures. Receivers
used in buildings with
metal siding or stucco may
experience inconsistent
signals
Move sensor closer
to your receiver and/
or remove any physical
objects between sensor
and receiver. If using in
a heavily wooded area,
or signal passes through
mulple buildings, your
eecve range will be
reduced