User's Manual

18 19
NC
COM
NO
5.3.2 To add a powered 12v accessory5.3 Connecng an External 12v Device
Your Guardline Driveway Alarm can trigger external devices
whenever a signal is received on your receiver. You can use
the 12v relay feature to acvate powered or unpowered 12v
external devices such as strobes or sirens. You can even use
the 12v relay to e your Guardline Driveway Alarm into an
exisng home alarm system.
5.3.1 To add an unpowered 12v external device:
Watch the video:
www.guardlinesecurity.com/12v-relay
1. Receiver must be plugged in with the power adapter
1. Receiver must be plugged in with the power adapter
2. Remove back plate and feed wires through
2. Remove back plate and feed wires through
4. Locate the 5 orange tabs and
follow the instrucons with your
12v device on how to connect it.
If you don’t have the instrucons,
follow the steps below:
4. Locate the 5 orange tabs and
follow the instrucons with your
12v device on how to connect it.
If you don’t have the instrucons,
follow the steps below:
5. Use the + and - terminals
6. Depress orange tab for the +
terminal and insert red wire fully, do
the same with the - terminal and insert
black wire
7. Acvate your sensor to make sure
it’s working fully
5. Use the NO or NC and the COM
terminals. Consult the instrucons on
your 12v device to conrm whether
you should use NC or NO terminals
6. Depress orange tab for either the
NO or NC terminal, then insert red
wire fully. Do the same with the COM
terminal and insert black wire
7. Acvate your sensor to make sure
it’s working fully
3. Turn on the switches that correspond to the zone(s) on your
receiver that you want to acvate:
3. Turn on the switches that correspond to the zone(s) on your
receiver that you want to acvate:
5
9
7
11
6
10
8
12
+
+
-
-
+
-
5: Zone 1
6: Zone 2
7: Zone 3
8: Zone 4
9: Zone 1
10: Zone 2
11: Zone 3
12: Zone 4