User's Manual

Hardware Accessories Installation
SPARC/CPU−56T 45
The actual memory module installation procedure is described in theaSPARC/MEM−550
Installation Guide
a which is delivered together with the memory module.a
Hard Disk
A hard disk is available for the CPU board on request. It can be connected to the IDE1
interface which is accessible via an on−board connector.
a
Before installing the hard disk you have to remove the I/O board and afterwards you
have to reinstall it. How this is done is described in the previous section "PMC Modules".
The actual installation of the hard disk is described in the Installation Guide delivered
together with the hard disk.
a
SCSI−U160 Cable
The SCSI−U160 cable is available as accessory kit called ACC/CABLE*SCSI*U160. It
provides a SCSI U160 cable with a length of three meters which has one SCSI*3 and one
SCSI*4 connector at its ends. It can be used to connect SCSI devices to the CPU board.
For details, refer to the
aACC/CABLE/SCSI−U160 Installation Guidea which is delivered
together with the accessory kit.
a
RS−422 Cable
The RS−422 cable is available as accessory kit called ACC/CABLE*RS*422 and
provides a serial cable with a length of 2.6 meters that has one male DSub9 RS*422 and
one female mini DSub9 RS*232 connector at its ends. It allows to connect RS*422
devices to the serial B interface of the CPU board. For details, refer to
the
aACC/CABLE/RS−422 Installation Guideawhich is delivered together with the accessory
kit.
a
PS/2 Splitter Cable
The PS/2 splitter cable can be connected to the SUN−type keyboard/mouse connecter of
the CPU board or its IOBP. It allows to operate a PS/2−style keyboard and mouse.
a