User's Manual

A.1.5 Check userApplication

Execute the “hvcm” command of RMS to start up userApplication and check if it is

normally running on all nodes.

● Shared disk – Check access to the shared disk on an operational node.

● Logical IP address – Check access to an operational node.

See “PRIMECLUSTER RMS Configuration and Administration” for the RMS command.

A.2 Create and set up Oracle resource

The Oracle-related resource is registered in userApplication that is created in Chapter 2.4.

Execute the following command on an arbitrary node.

# hvw –n <Definition name>

For further details, refer to PRIMECLUSTER RMS Configuration and Administration.

A.2.1 Application-Edit

The examples of Oracle environment setup are provided as follows:

1) Select Application-Edit in the “Main RMS management menu” page to edit

userApplication.

2) Select userApplication created in the “Application selection menu” page of Chapter 2.4.