User's Manual

3.2 Oracle stop during cluster operation
PRIMECLUSTER Wizard for Oracle monitors an Oracle system while PRIMECLUSTER is
running. If the Oracle system is stopped, this PRIMECLUSTER Wizard considers it as a failure.
Then, the Oracle system is restarted or switched over to a standby node. If maintenance work
such as Oracle cold backup is required, discontinue to monitor Oracle executing the following
command:
● When discontinuing
/opt/FJSVclora/sbin/hvoradisable application_name resource_name
● When restarting
/opt/FJSVclora/sbin/hvoraenable application_name resource_name
These commands are executed for the Oracle instance and listener resource on the node where
maintenance work is required.
See “Chapter 4 Command”.
Restart monitoring
When the Oracle instance and/or listener is stopped, and monitoring is discontinued,
restart the Oracle instance and/or listener before monitoring is restarted.
State transition during maintenance
When the Oracle system is not monitored, the state transition does not occur even in the
event of an Oracle failure. However, the state transition might occur because of other
glitches like disk failures.
userApplication during maintenance
When the “hvoradisable” command properly stops monitoring the resource, this brings the
resource Warning on Web-Based Admin View.
25