User's Manual

GDS setup

GDS should be set up as “shared disk for concurrent access” for scalable operation and

“switching disk” for standby operation. We recommend that you prepare the disk class for

Oracle system table space and other Oracle resources respectively. The MONITORONLY

attribute should be set up to “NO” for the Oracle system table space and “YES” for the other

Oracle resources.

userApplication setup

Create userApplication using userApplication Configuration Wizard. See “Chapter 6 Cluster

application configuration” of “PRIMECLUSTER Installation/Administration Guide”. In scalable

operation, userApplication should be created for each node. In standby operation, one

userApplication should be created for all operational nodes. The recommended values are as

follows:

● Scalable operation (Oracle9i RAC)

Operation=Standby

AutoSwitchOver = no

PersistentFault = 1

HaltFlag=Yes

Additional resources =Gds resource

● Standby operation

Operation =Standby

AutoSwitchOver = HostFailure|ResourceFailure|ShutDown

PersistentFault = 1

HaltFlag=Yes

Additional resources = Gds resource, Fsystem resource, Network resource

2.4.2

Check userApplication

Execute the “hvcm” command of RMS to start up userApplication and check if it is

normally running on all nodes.

● Shared disk – Check access to the shared disk on an operational node.

● Logical IP address – Check access to an operational node.