User's Manual

Hardware Accessories Installation
SPARC/CPU−56T 41
Installation Procedure
Note:a
S To ensure proper EMC shielding, either operate each PMC slot with a blind panel
or with a PMC module installed.
S If the SPARC/CPU−56T is upgraded with PMC modules, ensure that the blind
panels are stored in a safe place in order to be used again when removing the
respective PMC module.a
S Processor PMC modules are only supported in non−monarch mode.a
Removing I/O Board
Start
1. Remove the 14 screws from I/O board which fix it to CPU board