User's Manual

OpenBoot Firmware Diagnostics
100 SPARC/CPU−56T
The system responds by incrementing a number every second. Press any key to stop the
test.
Network
To monitor the network connection enter:
okawatch−net
Internal loopback test −− succeeded.
Transceiver check −− Using Onboard transceiver −− Link Up.
passed
Using Onboard transceiver −− Link Up.
Looking for Ethernet packets.
‘.’ is a good packet. ‘X’ is a bad packet.
Type any key to stop.
...........X...........................X..............
ok
The system monitors the network traffic. It displays a dot (.) each time it receives a valid
packet and displays an X each time it receives a packet with an error which can be
detected by the network hardware interface.
a
IDE Devices
The following is an example output obtained after enterring probe−ide.a
okaprobe−ide
aaaDevice 0aa( Primary Master )
aaaaaaaaaaNot Present
aa
aaaDevice 1aa( Primary Slave )
aaaaaaaaaaNot Present
aa
aaaDevice 2aa( Secondary Master )
aaaaaaaaaaRemovable ATAPI Model: TOSHIBA CD−ROM XM−6702B
aa
aaaDevice 3aa( Secondary Slave )
aaaaaaaaaaNot Present
aa
ok