Computer Hardware User Manual

23
CHAPTER
4
Network Configuration
This chapter describes how to edit the network host files after the adapter has been
installed on your system. This chapter contains the following sections:
■ “Configuring the Network Host Files” on page 23
■ “Setting Up a 10-Gigabit Ethernet Network on a Diskless Client System” on
page 25
■ “Installing the Solaris Operating System Over a 10-Gigabit Ethernet Network” on
page 27
■ “Booting Over the 10-Gigabit Ethernet Network for Solaris x86 and Linux
Systems” on page 30
Configuring the Network Host Files
After installing the driver software, you must create a hostname.nxgenumber file
for the adapter’s Ethernet interface. You must also create both an IP address and a
host name for its Ethernet interface in the /etc/hosts file.