User Manual

For a digital communication the optional USB programming kit is

required. Please connect each wire of the USB adapter cable with the

same coloured wire of the sensor cable by using the terminal block.

Press with a screw driver as shown in the picture to loose a contact.

Alternatively t

he USB cable can also be connected directly on the

sensor [► Cable Connections].

The sensor is offering two ways of digital communication:

 bidirectional communication (sending and receiving data)

 unidirectional communication (burst mode – the sensor is sending

data only)

Digital and Analog Mode combined

The CSlaser are able to work in the digital mode and simultaneously as analog device (4-20 mA).

In this case the sensor will be powered by the USB interface (5 V).

optris CSlaser – E2010-07-B