User Manual

Electrical Installation

Cable Connections

Basic version

The basic version is supplied without connection cable. To connect the CSlaser please

open at first the sensor backplane (4 screws). Please use a

4-wire shielded cable which you have to conduct through the cable gland. During

assembling please make sure the shield gets a safe electrical contact to the sensor

housing. For an easier connection the terminal block can be removed from the PCB by

pulling off.

Connector version

This version has a connector plug integrated in the sensor backplane. Therefore an

opening of the sensor for cable assembling is not necessary. Please use the original

ready-made, fitting connection cables which are optionally available. If you want to use

own cables please note the pin assignment of the connector (see next page).

Power supply

Please use a power supply unit with an output voltage of 5–28 VDC which can supply

100 mA.

optris CSlaser – E2010-07-B