Operation Manual
English
35
USING THE PROJECTOR
Image advanced signal (RGB) menu
Automatic
IMAGE
Exit
Advanced : Signal
Phase
On
Frequency
H. Position
V. Position
Note:
“Signal” is only supported in Analog VGA (RGB) signal.
If the “Signal” setting is set to automatic, the phase, frequency items are grayed out. If the “Signal”
setting is set to a specic input source, the phase, frequency items will appear for the user to manually
tune and are saved in the settings after the next time projector is turned off and on again.
Automatic
Automatically selects the signal. If this function is enabled, the Phase, frequency items are grayed out. If this
function is disabled, the phase, frequency items will appear for user to manually tune and saved in settings after the
next time projector turns off and on again.
Phase
Synchronize the signal timing of the display with the graphic card. If the image appears to be unstable or ickers,
use this function to correct it.
Frequency
Change the display data frequency to match the frequency of your computer's graphic card. Use this function only if
the image appears ickering vertical lines.
H. Position
Press the to move the image left.
Press the to move the image right.
V. Position
Press the to move the image down.
Press the to move the image up.
Exit
Choose "Exit" to exit the menu.