Operation Manual

English
20
USING THE PROJECTOR
Powering on / off the projector
Freeze
Power Switch
L
R
Keystone Volume
Page
-
-
+
-
+
1 2
Menu
3
3D
4
HDMI
5
VGA
6
Vide o
7
User 1
8
User 2
9
User 3
Source
0
Resync
Page+Laser
Enter
or
Powering on
Securely connect the power cord and signal / source cable. When connected, the On / Standby LED 1.
will turn red.
Turn on the projector by pressing the 2. " " either on the projector keypad or the remote control.
A start up screen will display in approximately 10 seconds and the On / Standby LED will be solid blue.3.
The rst time the projector is turned on, you will be prompted to select the preferred language, and otherNote:
settings.
Powering off
Turn off the projector by pressing the 1. " " either on the projector keypad or the remote control.
The following message will be displayed:2.
Power Off?
Press Power key again
Press the 3. " " again to conrm, otherwise the message will disappear after 15 seconds. When you
press the " " button for the second time, the projector will shut down.
The cooling fans will continue to operate for about 10 seconds for the cooling cycle and the On/4.
Standby LED will ash blue. When the On / Standby LED turns solid red, this indicates the projector
has entered standby mode. If you wish to turn the projector back on, you must wait until the cooling
cycle has nished and the projector has entered standby mode. When the projector is in standby
mode, simply press the " " button again to turn on the projector.
Disconnect the power cord from the electrical outlet and the projector.5.
It is not recommended that the projector is turned on immediately right after a power off procedure.Note: