Use and Care Manual

English
33
USING THE PROJECTOR
by using RS232 command.
 Test Pattern: Select the test pattern from Grid (Green), Grid (Magenta), Grid (White), White or disable
this function (None).
 Projection Mode: Select the preferred projection between Front, Rear, Front-Ceiling, and
Rear-Ceiling.
 HDMI EDID: Select the HDMI EDID type from 2.0 or 1.4.
Note: If you experience abnormal color issue, please adjust the EDID setting.
 HDMI/VGA/USB Disk: Dene how the system will react when one of the input sources (HDMI/VGA/
USB ash drive) is connected to the projector.
 Notication: Choose “Notication” to display the input switching conrmation message when an
input source is detected.
 Source Auto-change: Choose “Source Auto-change” to automatically switch to the currently
detected input source.
 None: Choose “None” to manually switch the input source.
 High Altitude: When “On” is selected, the fans will spin faster. This feature is useful in high altitude
areas where the air is thin.
 12V Trigger: Use this function to enable or disable the trigger.
12V
NC
GND
 On: Choose “On” to enable the trigger.
 Off: Choose “Off” to disable the trigger.
Info menu
View the projector information as listed below:
 Regulatory
 Serial Number
 Source
 Resolution
 Display Mode
 Brightness Mode
 Power Mode(Standby)
 Lamp Hour
 Filter Usage Hour
 Projector ID
 Color Depth
 Color Format
 FW Version
Reset all menu
Return the factory default settings for all settings.