Operation Manual

T:+44 1274 394125 F: +44 1274 730960 E: techsupport@calibreuk..com 25

3.11. System

This selection contains functions which are more applicable to system operation than to picture

adjustment.

3.11.1. User

Settings: USER 1, 2, 3, 4

A predefined setting stored under a user name can be selected. Several settings of the HQView-5xx

can be stored under a user name. Thus, different users can store their preferred HQView-5xx settings

and recall these profiles by picking up their user name from this menu.

Note: Using the Web interface, (any number of) settings can also be stored/restored to/from a PC disc

drive.

3.11.2. Names/Profiles

The Names/Profiles menu provides input masks to rename the generic input channels and user

names. User names and input channel names can be changed to any word with a maximum of 12

alpha numeric characters with a value range of 0-9, A-Z and blank.

The Names/Profiles menu allows the user to store profiles under a certain user name. It also allows to

copy user profiles by loading a profile stored under one user name and save it under another user

name. Reset Profile allows to restore default HQView-5xx settings for the currently selected user.

3.11.3. Input Config

Inputs can be configured through the following sub-menus:

VGA Setup:

Submenu for adjusting analogue computer video. A button for automatic setup of frequency and phase

of the sampling clock is provided. This automatic adjustment is strongly recommended. Frequency

(Clock) and phase can also be altered manually.

DVI/HDMI Setup:

The DVI-I connector will accept either DVI-D or VGA analogue inputs. The DVI-I channel can be

configured accordingly.

The equalisation of the DVI interface can be boosted to allow for extended cable length.

The automatic HDMI and DVI Color Space and Range settings can be overwritten in this menu. Range

can be set to limited video mode or full range. The color space can be set to RGB or YCbCr.

SDI Setup:

For 3GSDI Level B type input modes the stream can be chosen.

SDI audio input is routed to the HDMI and 3GSDI output connector by default. HQView-5xx can also

be set to monitor audio on the SPDIF connector. SDI Audio on the HDMI/3GSDI connector and SPDIF

connector are mutually exclusive.

Two consecutive SDI audio channels can be output on the HDMI/3GSDI output interface. The group

can be chosen. Or all eight SDI audio channels can be transmitted.

Component Setup:

The component interface of the HQView-5xx is configured through this submenu. The Colour Space

can be set to YPbPr or RGB. The sync signal can be stripped from the Green or Y channel with the

setting 3 Wire or from the separate sync line with the setting 4 Wire. The Auto setting will automatically

detect a sync signal and set-up the HQView-5xx accordingly. This is set in under Synchronisation.