User Manual
Table Of Contents
- SAFETY
- INTRODUCTION
- SETUP AND INSTALLATION
- USING THE PROJECTOR
- Powering on / off the projector
- Selecting an input source
- Menu navigation and features
- OSD Menu tree
- Display image settings menu
- Display 3D menu
- Display aspect ratio menu
- Display edge mask menu
- Display zoom menu
- Display image shift menu
- Display keystone menu
- Audio mute menu
- Audio volume menu
- Audio audio input menu
- Setup projection menu
- Setup lamp settings menu
- Setup filter settings menu
- Setup power settings menu
- Setup security menu
- Setup HDMI link settings menu
- Setup test pattern menu
- Setup remote settings menu
- Setup projector ID menu
- Setup options menu
- Setup reset menu
- Info menu
- maintenance
- additional information
English
47
ADDITIONAL INFORMATION
Projector dimensions and ceiling mount installation
1. To prevent damage to your projector, please use the Optoma ceiling mount.
2. If you wish to use a third party ceiling mount kit, please ensure the screws used to attach a mount to
the projector meet the following specications:
Screw type: M4*3
Minimum screw length: 10mm
Unit: mm
Lens
Note: Please note that damage resulting from incorrect installation will void the warranty.
Warning:
If you buy a ceiling mount from another company, please be sure to use the correct screw size.
Screw size will vary depending on the thickness of the mounting plate.
Be sure to keep at least 10 cm gap between the ceiling and the bottom of the projector.
Avoid installing the projector near a heat source.