User Manual
Table Of Contents
- SAFETY
- INTRODUCTION
- SETUP AND INSTALLATION
- USING THE PROJECTOR
- Powering on / off the projector
- Selecting an input source
- Menu navigation and features
- OSD Menu tree
- Display image settings menu
- Display 3D menu
- Display aspect ratio menu
- Display edge mask menu
- Display zoom menu
- Display image shift menu
- Display keystone menu
- Audio mute menu
- Audio volume menu
- Audio audio input menu
- Setup projection menu
- Setup lamp settings menu
- Setup filter settings menu
- Setup power settings menu
- Setup security menu
- Setup HDMI link settings menu
- Setup test pattern menu
- Setup remote settings menu
- Setup projector ID menu
- Setup options menu
- Setup reset menu
- Info menu
- maintenance
- additional information
English
17
SETUP AND INSTALLATION
Adjusting the projector image
Image height
The projector is equipped with elevator feet for adjusting the image height.
1. Locate the adjustable foot you wish to adjust on the underside of the projector.
2. Rotate the adjustable foot clockwise or counterclockwise to raise or lower the projector.
Tilt-Adjustment Feet
Tilt-Adjustment Ring
Zoom and focus
To adjust the image size, turn the zoom lever clockwise or counterclockwise to increase or decrease
the projected image size.
To adjust the focus, turn the focus ring clockwise or counterclockwise until the image is sharp and
legible.
Focus Ring
Zoom Lever
Note: The projector will focus at a distance of 1m to 10m.