User Manual
Table Of Contents
- SAFETY
- INTRODUCTION
- SETUP AND INSTALLATION
- USING THE PROJECTOR
- Powering on / off the projector
- Selecting an input source
- Menu navigation and features
- OSD Menu tree
- Display image settings menu
- Display 3D menu
- Display aspect ratio menu
- Display edge mask menu
- Display zoom menu
- Display image shift menu
- Display keystone menu
- Audio mute menu
- Audio volume menu
- Audio audio input menu
- Setup projection menu
- Setup lamp settings menu
- Setup filter settings menu
- Setup power settings menu
- Setup security menu
- Setup HDMI link settings menu
- Setup test pattern menu
- Setup remote settings menu
- Setup projector ID menu
- Setup options menu
- Setup reset menu
- Info menu
- maintenance
- additional information
English
15
SETUP AND INSTALLATION
Projector installation notice
Place the projector in a horizontal position.
The tilt angle of the projector should not exceed 15 degrees, nor should the projector be installed
in any way other than the desktop and ceiling mount, otherwise lamp life could decrease dramatically,
and may lead to other unpredictable damages.
15°
-15°
Allow at least 30 cm clearance around the exhaust vent.
Minimum 100mm
(3.94 inches)
Minimum 300mm
(11.81 inches)
Minimum 300mm
(11.81 inches)
Minimum 100mm
(3.94 inches)
Minimum 100mm
(3.94 inches)
Minimum 100mm
(3.94 inches)
Ensure that the intake vents do not recycle hot air from the exhaust vent.
When operating the projector in an enclosed space, ensure that the surrounding air temperature within
the enclosure does not exceed operation temperature while the projector is running, and the air intake
and exhaust vents are unobstructed.
All enclosures should pass a certied thermal evaluation to ensure that the projector does not recycle
exhaust air, as this may cause the device to shutdown even if the enclosure temperature is with the
acceptable operation temperature range.