User's Manual

English

MAINTENANCE

Note:

 The projector cannot be turned on if the lamp cover has not been placed back on the projector.

 Do not touch the glass area of the lamp. Hand oil can cause the lamp shatter. Use a dry cloth to clean

the lamp module if it was accidentally touched.

Installing and cleaning the dust lter

Installing the dust lter

Note: Dust lters are only required/supplied in the selected regions with excessive dust.

Cleaning the dust lter

We recommend you to clean the dust lter every three months. Clean it more often if the projector is used in a

dusty environment.

Procedure:

1. Switch off the power to the projector by pressing the " " button on the projector keypad or the “ ”

button on the remote control.

2. Disconnect the power cord.

3. Pull the dust lter compartment downwards to remove it out from the bottom of the projector. 1

4. Carefully remove the air lter. Then clean or replace the dust lter. 2

5. To install the dust lter, reverse the previous steps.