User's Manual

English
46
MAINTENANCE
Replacing the lamp (continued)
3
4
7
8
2
5
1
6
Procedure:
1. Switch off the power to the projector by pressing the “ ” button on the projector keypad or the “ ”
button on the remote control.
2. Allow the projector to cool down for at least 30 minutes.
3. Disconnect the power cord.
4. Push down rmly on the middle of the top cover to unlock the latch. 1
5. Open the top cover. 2
6. Loosen the 2 screws on the lamp cover. 3
7. Remove the lamp cover. 4
8. Loosen the screw on the lamp module. 5
9. Lift up the lamp handle. 6
10. Remove the lamp cord. 7
11. Remove the lamp module carefully. 8
12. To replace the lamp module, reverse the previous steps.
13. Turn on the projector and reset the lamp timer.
14. Lamp Reset: (i) Press "Menu"  (ii) Select "Setup"  (iii) Select "Lamp Settings"

(iv) Select "Lamp
Reset"

(v) Select "Yes".