User's Manual

OPN-2002n DOC ID：SS12xxx

9.5. Vibration Strength(without packing)

There shall be no sign of malfunction after the following vibration test.

Vibration test:

Increase the frequency of the vibration from 10Hz to 100Hz at an accelerated velocity of

19.6m/s2 (2.0 G) for 30 minutes (60 minutes for a cycle) in the non-operating state. Repeat this in each X, Y

and Z direction.

9.6. Vibration Strength (in individual packing)

There shall be no sign of malfunction after the following vibration test.

Vibration test:

Increase the frequency of the vibration from 10Hz to 100Hz at an accelerated velocity of 19.6

m/s2 (2.0 G) for 30 minutes (60 minutes for a cycle) in individually packaged state. Repeat this in each X, Y

and Z direction.

Drop Impact Strength

There shall be no sign of malfunction after the following drop test.

Drop test:

Drop the scanner three times (18 times in total), at each 6 face, from a height of 120cm onto a

concrete floor as shown below.

120cm

コンクリート

Figure 12:

Drop test

9.7. Drop Impact Strength (in individual packaging)

There shall be no sign of malfunction after the following drop test.

Drop test:

Drop an individually packaged scanner 10 times in total, at any of 1 corner, 3 edges, and 6 faces,

from a height of 150 cm onto a concrete floor.

9.8. Electrical Specifications

Air discharge ±8 kV max. (No malfunction)

±10 kV max. (No destruction)

Measurement environment An electrostatic testing device compliant with IEC 61000-4-2 is

used.

Discharge resistance 330 Ω

Charging capacitor 150 pF