User Manual

OPL-2724 SS08057
- -
12
10. Default Settings
To make it easier to configure the settings of OPL-2724 to the default settings, there are [U1] menu
barcodes. For communication settings, there are [INIT] menu barcodes.
At the time of shipment from the factory, all settings are configured to [U1]. ([INIT] menu barcodes are
included in [U1] menu barcodes.
[U1] Default Settings 1: Supported symbologies
Code type Reading
Transmit
code
length
Transmit CD
Calculate
CD
Transmit
others
Set
prefix
Set suffix
UPC-A ○ × ○ ○ ― CR
UPC-A Add-on × × ○ ○ ― CR
UPC-E ○ × × ○ ― CR
UPC-E Add-on × × × ○ ― CR
EAN-13 ○ × ○ ○ ― CR
EAN-13 Add-on × × ○ ○ ― CR
EAN-8 ○ × ○ ○ ― CR
EAN-8 Add-on × × ○ ○ ― CR
Code-39 ○ × ○ ×
ST/SP
Transmission
― CR
NW-7(Coda bar) ○ × × × Transmit as
abcd/abcd
― CR
D.2of5 ○ × ○ × ― CR
I.2of5 ○ × ○ × ― CR
Code-93 × × - ○ ― CR
Code-128 × × - ○ ― CR
EAN-128 × × - ○ CR
MSI/Plessey × × ○ ○ ― CR
IATA × × ○ × ― CR
Note:
1) In the “Reading” column,”○” means “Enable to read” and “×” means “Disable to read.”
2) In the “Transmit code length” column,”○” means “Transmit code length” and “×” means “Not
transmit code length.”
3) In the “Transmit CD” column,”○” means “Transmit check digit” and “×” means “Not transmit
check digit.
Also,”-” means “there is no setting for check digit transmission.”
4) In the “Calculate CD” column,”○” means “calculate check digit” and “×” means “do not calculate
check digit.”
5) In the “Setting prefix” column,”-” means “there is no setting for prefix.”