User's Manual

User Manual
OPTICON
Preliminary
Ve rsio n : 0.1
Da te : 96/ 07/ 10
136
Federal Communications Commission Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation. This
equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee does cause harmful interference to radio or TV reception, which can be determined
by turning the equipment on and off, the user is encourage to try to correct the interference by
one or more of the following measures:
z Reorient or relocate the receiving antenna.
z Increase the separation between the equipment and receiver.
z Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
z Consult the dealer or an experienced radio or television technician for help.
The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modif ications to this equipment. Such modif ications could void the user’s authority to operate
the equipment.
RF Exposure I nformation ( SAR)
This device meets the government’s requirements for exposure to radio waves. This device is
designed and manufactured not to exceed the emission limits for exposure to radio frequency
(RF) energy set by the Federal Communications Commission of the U.S. Government.
The exposure standard for wireless devices employs a unit of measurement known as the
Specif ic Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/ kg.
*
Test s f o r SAR ar e
conducted using standard operating positions accepted by the FCC with the device transmitting
at its highest certif ied power level in all tested frequency bands. Although the SAR is
determined at the highest certif ied power level, the actual SAR level of the device while
operating can be well below the maximum value. This is because the device is designed to
operate at multiple power levels so as to use only the poser required to reach the network. In
general, the closer you are to a wireless base station antenna, the lower the power output.