Integration Manual
GTM353W Integration Manual
Author:
R
. Claessens
Version:
4.0 Draft 2
Creation Date:
September 20, 2006
Page:
38 of 52
Option Confidential:
This document is Option Confidential - it may not be duplicated, neither distributed externally without prior and written permission of
Option NV.
+CSCS Select TE character set
Yes – but support for IRA
character set only
+CIMI Request international mobile
subscriber identity
Yes
Z Reset to default configuration Yes
&F Set to factory defined
configuration
Yes
I Request identification
information
Yes
+GMI Request manufacturer
identification
Yes
+GMM Request manufacturer
identification
Yes
+GMR Request revision identification Yes
+GSN Request revision identification Yes
+GCAP Request complete capabilities
list
Yes
6.3 Call control commands
All these commands are specified in 3GPP TS27.007 [1].
Command Description Used
+CSTA Select type of address TBD
D Dial
(using new dial modifiers,
“>”, “I/i”, “G/g”, and “;”
applicable to UMTS only)
>
= direct dial from phone book
I/i
= override CLIR
supplementary service default
G/g
= control CUG supplementary
service for call
;
= initiate voice call
Yes
+CHUP Hang up Yes – for voice call hangup
+CBST Select bearer service type Yes
+CRLP Radio link protocol Yes
+CR Service reporting control Yes
+CRC Cellular result codes Yes
T Select tone dialing Yes – but does nothing
P Select pulse dialing Yes – but does nothing
A Answer Yes
H Hook control Yes
O Return to online data state Yes
S0 Automatic answer Yes
S6 Pause before blind dialing Yes – but does nothing
S7 Connection completion
timeout
Yes – but does nothing
S8 Comma dial modifier time Yes – but does nothing
S10 Automatic connect delay Yes – but does nothing
L Monitor speaker loudness Yes – but does nothing
M Monitor speaker mode Yes – but does nothing
+DS Data compression Yes
+DR Data compression reporting Yes