User's Guide

Restoring the factory default settings

You can restore the factory default configuration for GlobeSurfer III+ when you want to build a new

network from scratch, or when changes to the network have become unclear.

Note: All web-based management settings and parameters, not only those in the advanced section, will

be restored to their default values. This includes the administrator password: the user-specified

password will no longer be valid.

All personal configuration settings are deleted, including all SMS messages in the unit. Messages on the

SIM card remain unchanged.

You can restore the factory settings as follows:

On the unit: press the Restore defaults button at the bottom of the GlobeSurfer III+ using a paper

clip.

From the GlobeSurfer III+ management console:

1. Select the ‘Advanced Mode’ and then chose the ‘System’ tab

2. Select the ‘Maintenance’ followed by ‘Restore Factory Settings’ sub-tabs

3. Read the warning and Click ‘OK’.

Then you will need to redo the Set-up as described from ‘Step 3: Connect your computer’ on page 13.

Firmware Upgrade

GlobeSurfer III+ firmware can be upgraded without losing any of your configurations and settings. The

firmware is upgraded by downloading a software image file from the Internet and installing on

GlobeSurfer III+.