User's Guide

45
•ConnectManually:connecttotheInternetbyclickingConnecton
the Connection Status page in the Graphical User Interface or press
the Connect button on GlobeSurfer
®
III.
•Automaticallyconnectupontrafc:GlobeSurfer
®
III will automatically
connect when you attempt to send data via the Internet.
•Incaseofinactivity,disconnectafter(minutes):Thedefaultis10minutes.Set
it to zero (0) if you want the UMTS to stay connected. The maximum is 1440
minutes (24 hours).
Note: Incoming traffic is treated as inactivity.
Wireless Setup
The following settings are the most important for the local Wireless LAN:
•SSID:TheServiceSetIdentier:enteranameforyourlocalwirelessnetwork
(WLAN) (maximum 32 characters).
•SSIDbroadcast:Ifyousetthe‘Enabled’checkboxtobroadcastthenother
devices can detect and connect to your WLAN. You can install the WLAN with
this feature enabled and then disable it once you have set up GlobeSurfer
®
III
and its associated wireless clients.
Tip: You can clear this checkbox later to disable broadcasting and hide the
name of your network; this provides minimal security, as other devices have to
know the SSID to connect.
Z08.209_UG_GSIII_V4.indd 45 14-08-2008 13:56:42