Getting Started Guide

Getting started

To get started, you need about 15 minutes and the following:

AT&T USBConnect Quicksilver

The Quicksilver sends and receives data between your laptop and the AT&T network.

The Quicksilver includes the necessary software for your Windows laptop and

will begin to auto-install when inserted for the first time. Mac users see page 8

before installing.

SIM Card

The SIM card stores the wireless number for your Quicksilver and your subscriber infor-

mation enabling access to the AT&T network.

Follow the easy steps for Windows Vista, XP and 2000 laptops on the next page.

Warning:

The Quicksilver device should be used with the LED indicator lights facing up or to either side for best perfor-

mance and safety. If trying to use the device with the LED indicators facing down, the user should maintain a

distance of at least ½ of an inch (12,7 mm) between the device and the user’s body.

Follow the steps below

1. Insert the SIM card and connect the Quicksilver (about 2 minutes)

• Open the Quicksilver by swiveling the cap to the right or left.

• Peel away the pull tab that extends over the USB connector from the bottom of the device.

• Use the pull tab to pull the dummy SIM from the slot.

• Insert the SIM into the slot directly above the USB connector.

• The notched portion of the SIM should go into the device first and be positioned

towards the back end of the device.

• Gently push the SIM card completely into the slot until it clicks into place and is

fully inserted.

• Inserted properly

• Not inserted properly

• Insert the Quicksilver into the laptop

Z08_193_X_GSG_ATT_150X100_land_V2.indd 6 28-08-2008 13:19:43