Instructions / Assembly

Cleaning Instruction

During Season Care:

 Before cleaning, be sure to turn off and unplug the unit.

 Keep the fan clean. Carefully wipe the unit with a soft, damp cloth. Please be very

cautious near the motor.

 DO NOT immerse the fan in water and never allow water to drip into the Motor

Housing.

 Never use gasoline, benzene or thinner. This will damage the surface of the unit.

 After cleaning, be sure to completely dry the unit with a cloth or towel.

After Season Care:

 Your fan can be stored in the off-season.

 Before putting the fan in storage, clean it thoroughly, cover it with a vinyl bag, and store

it in a cool and dry place. We recommend using the original (or appropriately sized) box.

SETTING UP

 Carefully remove your fan from the box (please save the carton for off-season storage).

 Make sure the unit is in the OFF position before plugging the unit into the outlet.

 For shipping purposes, the fan is packed unassembled.

ASSEMBLY

1. Unscrew the L shaped extension tube screw and washer from bottom of base tube.

2. Mount the base tube to the base and secured by extension tube screw (Fig 1).

3. Pull the inner extension pole inside the large base tube up and tighten the height by the

adjustment control knob.

4. Place the motor assembly on top of small extension pole and secure with setting screw.

5. Remove the fan blade cap on the end of motor shaft by turning clockwise and rear grill

setting nut in front of motor housing by turning counterclockwise.

6. Set the rear grill in the proper position with the handle up. Secure the rear grill by using

the setting nut to tightly attach it to the motor housing.

PAGE 1
Cleaning Instruction During Season Care:      Before cleaning, be sure to turn off and unplug the unit. Keep the fan clean. Carefully wipe the unit with a soft, damp cloth. Please be very cautious near the motor. DO NOT immerse the fan in water and never allow water to drip into the Motor Housing. Never use gasoline, benzene or thinner. This will damage the surface of the unit. After cleaning, be sure to completely dry the unit with a cloth or towel.
PAGE 2
7. Install the fan blade on the shaft until it reaches the retaining pin and tighten the fan blade cap counterclockwise. OPERATING 1. Place fan on a firm level surface. 2. Plug the power cord into any standard 120V AC, 60HZ outlet. Please make sure the Selector (Speed Control) is in the OFF position. A lose fit between the AC outlet and plug may cause over heating of the plug. Have a qualified electrician to replace the old outlet if the power cord feels extremely hot. 3.
PAGE 3