Installation Instructions

3
Product Data Sheet 2203 Version: 1
Sections
321400 321413 321416 321440
HARDSCAPE
Jointing Sand
Activating the Jointing Sand
1. Work in sections of about 10 m2 (100 ft2).
2. Use a water hose equipped with a fan shower head working at low to medium pressure.
3. Starting at the highest elevation of your surface, position the shower head at 2 to 3 ft
(.6 to 1 m) from the surface and shower the surface in a sweeping movement from left to right.
Clean the surface rapidly while allowing the water to slowly migrate, absorb and channel into
the joints. Continue to water until the joints are thoroughly wet, a good indicator is when you
see water standing on the joints.
4. Focus on watering the pavement and not the joints. By doing so, you will remove any fine
particles that could have adhered to the pores of the pavement surface. If pooling of water
occurs on top of the joints, proceed to wet another area.
Testing
Before using this product, always test on a small area 1.0 m2 (10 ft2) of your pavement making
sure to follow the instructions carefully. Let dry for 24 hours. If you are satisfied with the results,
proceed with the entire surface area.
Coverage
Depending on the width of your pavement joints, a 22.7 kg (50 lb.) bag of OPTIMATRIX
Polymeric Jointing Sand will cover from 3.0 to 10.0 m2 (30 to 100 ft2).
Health & Safety
Refer to the Safety Data Sheet (SDS) for additional information on this product.
Caution
Sweeping may cause airborne dust. Avoid breathing dust. Wear a regulated safety mask
(NIOSH).
Warning
This product contains silica crystals which are known to the state of California to cause cancer.
Cleaning
Clean hands and tools with soap and water.
Limited Warranty
This premium quality product was designed to satisfy the user. If you are not satisfied after
Surface Testing on a small area, please contact our technical service department immediately.
NO WARRANTIES expressed or implied are offered by DYNA. The Manufacturer’s liability is
limited to the replacement of products proven defective. The user assumes all risks and
liabilities associated with the use of this product.
Notice
DYNA shall not be liable for incidental and consequential damages, indirectly or directly
sustained, nor for any loss by application of these goods not in accordance with the printed
instructions or for other than the intended use. Before using the user shall determine the
suitability of the product for its intended use and the user will assume all risks and liabilities that
may arise in connection therewith. Our liability is expressly limited to the replacement of
defective goods. Any claim shall be deemed waived unless the claim is made in writing to us
within 15 days from the date it was, or reasonably should have been, discovered that the product
was defective.
POLYMERIC JOINTING SAND QUICK SETTING / DUST FREE