User Guide
Table Of Contents
All Up loudspeakers are tted with 4 pin Euroblock connectors. The terminals are wired as follows:
Pin 1 : Negative In Pin 2 : Negative link through
Pin 3 : Positive In Pin 4 : Positive link through
To connect the cable to the loudspeaker terminals, follow this procedure.
Replace the plate by reversing the procedure.
! When wiring loudspeaker cables be careful to observe the correct polarity of the cable and connector at both ends.
Connecting Up
Undo the two screws that secure
the protective plate on the top of
the back can
Slide the plate sideways and lift off Pass the cable(s) through the cable grip
Connect to the Euroblock terminals as
shown above
5/10
Up
Ceiling Loudspeakers
Loudspeakers
USER GUIDE
© 2022. Optimal Audio Group Ltd. (v1.1)
Introduction
Overview
Fitting up
Connecting up
Matching
speakers and
amps
>
<
Specications
Safety
information