User Guide

Table Of Contents

To use the weatherproof connection cover, rstly run the input and link output

(where used) cables through the glands.

Trim the cable ends to t into the loudspeaker’s euroblock connector, without

leaving excessive exposed conductor, as this can easily short the two cores

together. Doing so will cause your amplier to protect itself, and no sound will

come from the loudspeaker.

Be sure to observe correct loudspeaker polarity.

Where present, make sure you have the correct tapping selected from the rotary

control beneath the input connector. Then push the cable mounted connector

into the speaker, and slide the cover over the cable until it ts against the recess

in the back of the speaker.

Insert the four screws to secure in place, tight enough to seal against the cabinet

but not over tight.

Finally, tighten the cable gland onto the cable(s) to provide a good seal. If only

one gland is used, tighten the second as far as you can.

Fitting weatherproof connector –Cuboid 3, 3TX, 5 and 5TX

17/23

Cuboid

Loudspeakers

USER GUIDE

Introduction

Aiming/

coverage

Overview

Horizontal

coverage

Wall mount

Connecting up

Ceiling mount

Matching

speakers/amps

Grille removal

Accessories

Badge rotation

Specications

Coverage

Horn rotation

Safety info