Quick Start Guide

Basic connection
After purchasing receiver, unpack it and
check to make sure that all of the following
items are included in the packaging:
• Receiver
• Remote controller
• Quick Start manual
• Batteries - 2x AAA (optional)
To install the batteries in the remote control,
remove the flap protecting the battery
compartment If inside the chamber there are
used batteries, they must be removed. Then
put new batteries inside. When installing the
battery, pay special attention on the polarity
- the direction of insertion of both batteries.
The correct polarity of batteries is drawn on a
description inside the battery compartment
in the remote control. After installing the
batteries, place protecting flap on its original
position.
Next, connect cable from LNB/ANTENNA (1
on picture) to receiver’s (3) SAT IN connector.
Using SCART cable (4) connect receiver with
TV Set (2). Finally, at the end connect main
cord (5) to main socket.
Turn on the TV Set. After while on TV Set
screen You should see receiver’s OSD. If TV
Set not display receiver’s OSD, probably
signal source is set wrong in TV. Check TV Set
documentation for information how to
change signal source.