Scanner User Manual
Table Of Contents
- April 2002
- Part I
- General Information
- Unpacking
- Factory Technical Support
- Part II Installation and SetUp
- A.\) Installation – Keyboard Wedge Interface
- Reset All Defaults – Keyboad Wedge Interface
- Computer Type Selection (for Keyboard Wedge only)
- Intercharacter Delay for Keyboard Wedge interface
- B.\) Installation – RS232 Interface
- Reset All Defaults – RS232
- RS-232C Communication Parameters
- Handshaking Protocol
- Baud Rate
- Data Bits / Stop Bits / Parity
- C.\) Installation – USB Interface
- Reset All Defaults - USB Interface
- Part III Bar Code Menu Functions
- Section A Programming the Scanner
- Symbology Selection
- Symbology Additions
- Setting the Number of Characters to be Scanned
- UPC Settings
- EAN-13 and EAN-8 Settings
- Code 39 Settings
- Codabar Settings
- MSI/Plessey Settings
- Code 128, EAN 128 Settings
- IATA Settings
- Telepen Settings
- Case Conversion
- Setting a Prefix or Suffix
- Prefix Settings
- Suffix Settings
- Direct Input Keyboard Keys
- Direct Input Characters
- Direct Input Control Characters
- Direct Input Code ID/Length
- Read Mode Settings
- Trigger Settings
- Multiple Read Reset Time
- Quiet Zone Settings
- Read Time Settings
- Redundant Decoding Settings
- Positive and Negative Bar Codes
- Buzzer Settings
- Good Read LED
- Diagnostics
Manual No. 25-ULGPMU01-01 Series OPT Handheld CCD Scanner
Page 9
RS-232C Communication Parameters
Handshaking Protocol
ZZ
Start
Program
Menu
-[[-
P0
None
-Q1-
Β
HP04
RTS/CTS
+IQ15+
P3
ACK/NAK
-Q!-
ZG
Xon/Xoff
-[H-
I0
Flow
Control
Time
Unlimited
-J1-
Β
I1
Flow
Control:
100ms
-J2-
I2
Flow
Control:
200ms
-J3-
I3
Flow
Control:
400ms
-J!-
Baud Rate
K7
19200
-L8-
K6
9600
-L7-
Β
K5
4800
-L6-
K4
2400
-L5-
K3
1200
-L!-
K2
600
-L3-