Scanner User Manual
Table Of Contents
- April 2002
- Part I
- General Information
- Unpacking
- Factory Technical Support
- Part II Installation and SetUp
- A.\) Installation – Keyboard Wedge Interface
- Reset All Defaults – Keyboad Wedge Interface
- Computer Type Selection (for Keyboard Wedge only)
- Intercharacter Delay for Keyboard Wedge interface
- B.\) Installation – RS232 Interface
- Reset All Defaults – RS232
- RS-232C Communication Parameters
- Handshaking Protocol
- Baud Rate
- Data Bits / Stop Bits / Parity
- C.\) Installation – USB Interface
- Reset All Defaults - USB Interface
- Part III Bar Code Menu Functions
- Section A Programming the Scanner
- Symbology Selection
- Symbology Additions
- Setting the Number of Characters to be Scanned
- UPC Settings
- EAN-13 and EAN-8 Settings
- Code 39 Settings
- Codabar Settings
- MSI/Plessey Settings
- Code 128, EAN 128 Settings
- IATA Settings
- Telepen Settings
- Case Conversion
- Setting a Prefix or Suffix
- Prefix Settings
- Suffix Settings
- Direct Input Keyboard Keys
- Direct Input Characters
- Direct Input Control Characters
- Direct Input Code ID/Length
- Read Mode Settings
- Trigger Settings
- Multiple Read Reset Time
- Quiet Zone Settings
- Read Time Settings
- Redundant Decoding Settings
- Positive and Negative Bar Codes
- Buzzer Settings
- Good Read LED
- Diagnostics
Manual No. 25-ULGPMU01-01 Series OPT Handheld CCD Scanner
Page 7
Intercharacter Delay for Keyboard Wedge interface
The scanner may send data faster than the computer or application program can accept. This is called "keyboard buffer overrun".
If data appears to be missing, random read errors occur or the scanner locks up and will not scan, experiment with the various
keyboard timing options listed in the menu to follow.
ZZ
Start Program
Menu
-[[-
LA
No Delay
-MB-
Β
LB
Delay = 1
-MB-
LC
Delay = 2
-MD-
LD
Delay = 3
-ME-
LE
Delay = 4
-MF-
LF
Delay = 5
-MG-
LG
Delay = 6
-MH-
LH
Delay = 7
-MI-
LI
Delay = 8
-MJ-
LJ
Delay = 9
-MK-
LK
Delay = 10
-ML-
ZZ
End Program
Menu
-[[-
+