Scanner User Manual
Table Of Contents
- April 2002
- Part I
- General Information
- Unpacking
- Factory Technical Support
- Part II Installation and SetUp
- A.\) Installation – Keyboard Wedge Interface
- Reset All Defaults – Keyboad Wedge Interface
- Computer Type Selection (for Keyboard Wedge only)
- Intercharacter Delay for Keyboard Wedge interface
- B.\) Installation – RS232 Interface
- Reset All Defaults – RS232
- RS-232C Communication Parameters
- Handshaking Protocol
- Baud Rate
- Data Bits / Stop Bits / Parity
- C.\) Installation – USB Interface
- Reset All Defaults - USB Interface
- Part III Bar Code Menu Functions
- Section A Programming the Scanner
- Symbology Selection
- Symbology Additions
- Setting the Number of Characters to be Scanned
- UPC Settings
- EAN-13 and EAN-8 Settings
- Code 39 Settings
- Codabar Settings
- MSI/Plessey Settings
- Code 128, EAN 128 Settings
- IATA Settings
- Telepen Settings
- Case Conversion
- Setting a Prefix or Suffix
- Prefix Settings
- Suffix Settings
- Direct Input Keyboard Keys
- Direct Input Characters
- Direct Input Control Characters
- Direct Input Code ID/Length
- Read Mode Settings
- Trigger Settings
- Multiple Read Reset Time
- Quiet Zone Settings
- Read Time Settings
- Redundant Decoding Settings
- Positive and Negative Bar Codes
- Buzzer Settings
- Good Read LED
- Diagnostics
Manual No. 25-ULGPMU01-01 Series OPT Handheld
CCD Scanner
Page 60
Read Time Settings
ZZ
Start/End
Program
Menu
-[[-
Y0
0 seconds
-Z1-
Y1
1 second
-Z2-
Y2
2 seconds
-Z3-
%
Y3
3 seconds
-Z!-
Y4
4 seconds
-Z5-
Y5
5 seconds
-Z6-
Y6
6 seconds
-Z7-
Y7
7 seconds
-Z8-
Y8
8 seconds
-Z9-
YL
Read time
x 10
-ZM-
YM
Indefinitely
-ZN-
Read Time Settings - the length of the period that the reader is ON after the trigger switch is pressed, or (in
multiple or continuous read mode) after a label has been read. Selecting a read time of 0 means that the reader will
stay ON as long as the trigger switch is being pressed. Selecting a read time for readers without a trigger switch, or
when the trigger switch is disabled, has no effect.