Scanner User Manual
Table Of Contents
- April 2002
- Part I
- General Information
- Unpacking
- Factory Technical Support
- Part II Installation and SetUp
- A.\) Installation – Keyboard Wedge Interface
- Reset All Defaults – Keyboad Wedge Interface
- Computer Type Selection (for Keyboard Wedge only)
- Intercharacter Delay for Keyboard Wedge interface
- B.\) Installation – RS232 Interface
- Reset All Defaults – RS232
- RS-232C Communication Parameters
- Handshaking Protocol
- Baud Rate
- Data Bits / Stop Bits / Parity
- C.\) Installation – USB Interface
- Reset All Defaults - USB Interface
- Part III Bar Code Menu Functions
- Section A Programming the Scanner
- Symbology Selection
- Symbology Additions
- Setting the Number of Characters to be Scanned
- UPC Settings
- EAN-13 and EAN-8 Settings
- Code 39 Settings
- Codabar Settings
- MSI/Plessey Settings
- Code 128, EAN 128 Settings
- IATA Settings
- Telepen Settings
- Case Conversion
- Setting a Prefix or Suffix
- Prefix Settings
- Suffix Settings
- Direct Input Keyboard Keys
- Direct Input Characters
- Direct Input Control Characters
- Direct Input Code ID/Length
- Read Mode Settings
- Trigger Settings
- Multiple Read Reset Time
- Quiet Zone Settings
- Read Time Settings
- Redundant Decoding Settings
- Positive and Negative Bar Codes
- Buzzer Settings
- Good Read LED
- Diagnostics
Manual No. 25-ULGPMU01-01 Series OPT Handheld
CCD Scanner
Page 58
Trigger Settings
ZZ
Start/End
Program
Menu
-[[-
S7
Disable
trigger
-T8-
S8
Enable
trigger
-T9-
Disable Trigger - This is applicable to readers which have a trigger switch. When this option is selected, the reader
will stay ON all the time.
Multiple Read Reset Time
ZZ
Start/End
Program
Menu
-[[-
AH
50 ms
-BI-
AI
100 ms
-BJ-
AJ
200 ms
-BK-
AK
300 ms
-BL-
AL
400 ms
-BM-
AM
500 ms
-BN-
%
AN
600 ms
-BO-
Multiple Read Reset Time - This option can be used in conjunction with multiple read mode. It sets the time the
reader should be pointed away from the label before it can decode the same label again.