Scanner User Manual
Table Of Contents
- April 2002
- Part I
- General Information
- Unpacking
- Factory Technical Support
- Part II Installation and SetUp
- A.\) Installation – Keyboard Wedge Interface
- Reset All Defaults – Keyboad Wedge Interface
- Computer Type Selection (for Keyboard Wedge only)
- Intercharacter Delay for Keyboard Wedge interface
- B.\) Installation – RS232 Interface
- Reset All Defaults – RS232
- RS-232C Communication Parameters
- Handshaking Protocol
- Baud Rate
- Data Bits / Stop Bits / Parity
- C.\) Installation – USB Interface
- Reset All Defaults - USB Interface
- Part III Bar Code Menu Functions
- Section A Programming the Scanner
- Symbology Selection
- Symbology Additions
- Setting the Number of Characters to be Scanned
- UPC Settings
- EAN-13 and EAN-8 Settings
- Code 39 Settings
- Codabar Settings
- MSI/Plessey Settings
- Code 128, EAN 128 Settings
- IATA Settings
- Telepen Settings
- Case Conversion
- Setting a Prefix or Suffix
- Prefix Settings
- Suffix Settings
- Direct Input Keyboard Keys
- Direct Input Characters
- Direct Input Control Characters
- Direct Input Code ID/Length
- Read Mode Settings
- Trigger Settings
- Multiple Read Reset Time
- Quiet Zone Settings
- Read Time Settings
- Redundant Decoding Settings
- Positive and Negative Bar Codes
- Buzzer Settings
- Good Read LED
- Diagnostics
Manual No. 25-ULGPMU01-01 Series OPT Handheld
CCD Scanner
Page 55
Direct Input Control Characters (continued)
ZZ
Start/End
Program
Menu
-[[-
1N
^N(SO)
-2O-
1O
^O(SI)
-2P-
1P
^P(DLE)
-2Q-
1Q
^Q(DC1)
-2R-
1R
^R(DC2)
-2S-
1S
^S(DC3)
-2T-
1T
^T(DC4)
-2U-
1U
^U(NAK)
-2V-
1V
^V(SYN)
-2W-
1W
^W(ETB)
-2X-
1X
^X(CAN)
-2Y-
1Y
^Y(EM)
-2Z-
1Z
^Z(SUB)
-2[-
9A
^[(ESC)
-:B-
CONTINUED ON NEXT PAGE...