Scanner User Manual
Table Of Contents
- April 2002
- Part I
- General Information
- Unpacking
- Factory Technical Support
- Part II Installation and SetUp
- A.\) Installation – Keyboard Wedge Interface
- Reset All Defaults – Keyboad Wedge Interface
- Computer Type Selection (for Keyboard Wedge only)
- Intercharacter Delay for Keyboard Wedge interface
- B.\) Installation – RS232 Interface
- Reset All Defaults – RS232
- RS-232C Communication Parameters
- Handshaking Protocol
- Baud Rate
- Data Bits / Stop Bits / Parity
- C.\) Installation – USB Interface
- Reset All Defaults - USB Interface
- Part III Bar Code Menu Functions
- Section A Programming the Scanner
- Symbology Selection
- Symbology Additions
- Setting the Number of Characters to be Scanned
- UPC Settings
- EAN-13 and EAN-8 Settings
- Code 39 Settings
- Codabar Settings
- MSI/Plessey Settings
- Code 128, EAN 128 Settings
- IATA Settings
- Telepen Settings
- Case Conversion
- Setting a Prefix or Suffix
- Prefix Settings
- Suffix Settings
- Direct Input Keyboard Keys
- Direct Input Characters
- Direct Input Control Characters
- Direct Input Code ID/Length
- Read Mode Settings
- Trigger Settings
- Multiple Read Reset Time
- Quiet Zone Settings
- Read Time Settings
- Redundant Decoding Settings
- Positive and Negative Bar Codes
- Buzzer Settings
- Good Read LED
- Diagnostics
Manual No. 25-ULGPMU01-01 Series OPT Handheld
CCD Scanner
Page 54
Direct Input Control Characters
ZZ
Start/End
Program
Menu
-[[-
9G
^@(NULL)
-:H-
1A
^A(SOH)
-2B-
1B
^B(STX)
-2C-
1C
^C(ETX)
-2D-
1D
^D(EOT)
-2E-
1E
^E(ENQ)
-2F-
1F
^F(ACK)
-2G-
1G
^G(BEL)
-2H-
1H
^H(BS)
-2I-
1I
^I(HT)
-2J-
1J
^J(LF)
-2K-
1K
^K(VT)
-2L-
1L
^L(FF)
-2M-
1M
^M(CR)
-2N-
CONTINUED ON NEXT PAGE...