Scanner User Manual
Table Of Contents
- April 2002
- Part I
- General Information
- Unpacking
- Factory Technical Support
- Part II Installation and SetUp
- A.\) Installation – Keyboard Wedge Interface
- Reset All Defaults – Keyboad Wedge Interface
- Computer Type Selection (for Keyboard Wedge only)
- Intercharacter Delay for Keyboard Wedge interface
- B.\) Installation – RS232 Interface
- Reset All Defaults – RS232
- RS-232C Communication Parameters
- Handshaking Protocol
- Baud Rate
- Data Bits / Stop Bits / Parity
- C.\) Installation – USB Interface
- Reset All Defaults - USB Interface
- Part III Bar Code Menu Functions
- Section A Programming the Scanner
- Symbology Selection
- Symbology Additions
- Setting the Number of Characters to be Scanned
- UPC Settings
- EAN-13 and EAN-8 Settings
- Code 39 Settings
- Codabar Settings
- MSI/Plessey Settings
- Code 128, EAN 128 Settings
- IATA Settings
- Telepen Settings
- Case Conversion
- Setting a Prefix or Suffix
- Prefix Settings
- Suffix Settings
- Direct Input Keyboard Keys
- Direct Input Characters
- Direct Input Control Characters
- Direct Input Code ID/Length
- Read Mode Settings
- Trigger Settings
- Multiple Read Reset Time
- Quiet Zone Settings
- Read Time Settings
- Redundant Decoding Settings
- Positive and Negative Bar Codes
- Buzzer Settings
- Good Read LED
- Diagnostics
Manual No. 25-ULGPMU01-01 Series OPT Handheld CCD Scanner
Page 5
Part II Installation and SetUp
This section of the manual contains information on the physical installation of the scanner as well as certain programming options.
There is a separate section for each type of interface. Check to see which type of interface your scanner has and turn to that
section for information on installing the scanner
A.) Installation – Keyboard Wedge Interface
A "Y" connection cable is required for installation. The scanner is installed or "wedged" between the keyboard and the computer..
Your “Y” cable should have connectors for both a PS2 and AT type installation. The "Y" cable connects both the scanner and the
keyboard to the computer.
The scanner must match the type of computer being used. The default setting is for an IBM AT type computer. If this type does
not match the host computer, refer to the “Computer Type Selection” in the programming section that follows. If the connector
does not match the host compute remove the short cable section, reverse it and insert it in the other connector