Scanner User Manual
Table Of Contents
- April 2002
- Part I
- General Information
- Unpacking
- Factory Technical Support
- Part II Installation and SetUp
- A.\) Installation – Keyboard Wedge Interface
- Reset All Defaults – Keyboad Wedge Interface
- Computer Type Selection (for Keyboard Wedge only)
- Intercharacter Delay for Keyboard Wedge interface
- B.\) Installation – RS232 Interface
- Reset All Defaults – RS232
- RS-232C Communication Parameters
- Handshaking Protocol
- Baud Rate
- Data Bits / Stop Bits / Parity
- C.\) Installation – USB Interface
- Reset All Defaults - USB Interface
- Part III Bar Code Menu Functions
- Section A Programming the Scanner
- Symbology Selection
- Symbology Additions
- Setting the Number of Characters to be Scanned
- UPC Settings
- EAN-13 and EAN-8 Settings
- Code 39 Settings
- Codabar Settings
- MSI/Plessey Settings
- Code 128, EAN 128 Settings
- IATA Settings
- Telepen Settings
- Case Conversion
- Setting a Prefix or Suffix
- Prefix Settings
- Suffix Settings
- Direct Input Keyboard Keys
- Direct Input Characters
- Direct Input Control Characters
- Direct Input Code ID/Length
- Read Mode Settings
- Trigger Settings
- Multiple Read Reset Time
- Quiet Zone Settings
- Read Time Settings
- Redundant Decoding Settings
- Positive and Negative Bar Codes
- Buzzer Settings
- Good Read LED
- Diagnostics
Manual No. 25-ULGPMU01-01 Series OPT Handheld
CCD Scanner
Page 39
Setting a Prefix or Suffix
A Prefix and Suffix consisting of a maximum 4 direct input entries each may be included in front and at the end of
the string, respectively.
The following steps are used to establish a Prefix or Suffix that will be transmitted with the bar code data.
1) Scan Start/End Program Menu to enter programming mode.
2) Scan the bar code representing the desired symbology you wish to add a Prefix or Suffix to.
3) Scan the character(s) that comprise the Prefix or Suffix. Up to 4 numbers, letters or control characters may
be used.
4) Scan Start/End Program Menu to exit programming mode.
Prefix Settings
ZZ
Start/End
Program
Menu
-[[-
GL
Matrix 2of5
-HM-
I8
IATA
-J9-
L8
Telepen
-M9-
M0
UPC-A
+ add-on
/N1-
M1
UPC-E
+ add-on
-N2-
M2
EAN-13
+ add-on
-N!-
M3
EAN-8
+ add-on
-N!-
M4
Code 39
-N5-
M5
Codabar
-N6-
M6
Industrial 2of5
-N7-
CONTINUED ON NEXT PAGE...