Scanner User Manual
Table Of Contents
- April 2002
- Part I
- General Information
- Unpacking
- Factory Technical Support
- Part II Installation and SetUp
- A.\) Installation – Keyboard Wedge Interface
- Reset All Defaults – Keyboad Wedge Interface
- Computer Type Selection (for Keyboard Wedge only)
- Intercharacter Delay for Keyboard Wedge interface
- B.\) Installation – RS232 Interface
- Reset All Defaults – RS232
- RS-232C Communication Parameters
- Handshaking Protocol
- Baud Rate
- Data Bits / Stop Bits / Parity
- C.\) Installation – USB Interface
- Reset All Defaults - USB Interface
- Part III Bar Code Menu Functions
- Section A Programming the Scanner
- Symbology Selection
- Symbology Additions
- Setting the Number of Characters to be Scanned
- UPC Settings
- EAN-13 and EAN-8 Settings
- Code 39 Settings
- Codabar Settings
- MSI/Plessey Settings
- Code 128, EAN 128 Settings
- IATA Settings
- Telepen Settings
- Case Conversion
- Setting a Prefix or Suffix
- Prefix Settings
- Suffix Settings
- Direct Input Keyboard Keys
- Direct Input Characters
- Direct Input Control Characters
- Direct Input Code ID/Length
- Read Mode Settings
- Trigger Settings
- Multiple Read Reset Time
- Quiet Zone Settings
- Read Time Settings
- Redundant Decoding Settings
- Positive and Negative Bar Codes
- Buzzer Settings
- Good Read LED
- Diagnostics
Manual No. 25-ULGPMU01-01 Series OPT Handheld
CCD Scanner
Page 36
IATA Settings
ZZ
Start/End
Program
Menu
-[[-
4H
Do not
check CD
-!5I-
%
4I
Check S/N
only
-5J-
4J
Check CPN,
S/N
-5K-
4K
Check CPN,
airline and
S/N
-5L-
4L
Transmit CD
-5M-
%
4M
Do not
transmit CD
-5N-
IATA is a variable length symbology with an optional check digit and non printable start/stop characters. Supported
characters include numeric digits 0 through 9.
The checksum is calculated as the modulo seven of the data string. IATA is acronym for International Air Transport
Association.
String format - A possible format of IATA is as follows:
Code
CPN AC FC SN CD
Description
Coupon Airline Code Form Code Serial Number Check Digit
Digits
1 3 2 8 15
Options for IATA:
* Enable check digit check.
* Selection of the check digit calculation.
* Disable transmission of the check digit.
Check digit - If the check digit calculation is required, then the appropriate calculation method must be selected.