Scanner User Manual
Table Of Contents
- April 2002
- Part I
- General Information
- Unpacking
- Factory Technical Support
- Part II Installation and SetUp
- A.\) Installation – Keyboard Wedge Interface
- Reset All Defaults – Keyboad Wedge Interface
- Computer Type Selection (for Keyboard Wedge only)
- Intercharacter Delay for Keyboard Wedge interface
- B.\) Installation – RS232 Interface
- Reset All Defaults – RS232
- RS-232C Communication Parameters
- Handshaking Protocol
- Baud Rate
- Data Bits / Stop Bits / Parity
- C.\) Installation – USB Interface
- Reset All Defaults - USB Interface
- Part III Bar Code Menu Functions
- Section A Programming the Scanner
- Symbology Selection
- Symbology Additions
- Setting the Number of Characters to be Scanned
- UPC Settings
- EAN-13 and EAN-8 Settings
- Code 39 Settings
- Codabar Settings
- MSI/Plessey Settings
- Code 128, EAN 128 Settings
- IATA Settings
- Telepen Settings
- Case Conversion
- Setting a Prefix or Suffix
- Prefix Settings
- Suffix Settings
- Direct Input Keyboard Keys
- Direct Input Characters
- Direct Input Control Characters
- Direct Input Code ID/Length
- Read Mode Settings
- Trigger Settings
- Multiple Read Reset Time
- Quiet Zone Settings
- Read Time Settings
- Redundant Decoding Settings
- Positive and Negative Bar Codes
- Buzzer Settings
- Good Read LED
- Diagnostics
Manual No. 25-ULGPMU01-01 Series OPT Handheld
CCD Scanner
Page 32
MSI/Plessey Settings
ZZ
Start/End
Program
Menu
-[[-
4A
Do not
check CD
-5B-
4B
Check 1 CD =
Mod 10
-5C-
%
4C
Check 2 CD's
= Mod 10
/Mod 10
-%D-
4D
Check 2 CD's
= Mod 10
/Mod 11
-5E-
4E
Transmit CD1
-5F-
%
4F
Transmit CD1
and CD2
-5G-
4G
Do not
transmit CD
-5H-
4R
Check 2 CD's
= Mod 11
/Mod 10
-5S-
MSI Plessey is a variable length symbology with one or two optional check digit calculations CD1 and CD2 and
non printable start/stop characters. Supported characters include numeric digits 0 through 9.
The checksum is calculated as the sum modulo 10 or 11 of the data characters. The checksum CD2 is calculated as
the sum modulo 10 or 11 of the data characters and CD1.
String format:
data (1 to
13 digits)
CD1 CD2
Options for MSI/Plessey:
* Disable check digit check.
* Selection of the check digit calculation.
* Selection of the number of check digits to be transmitted.