Scanner User Manual
Table Of Contents
- April 2002
- Part I
- General Information
- Unpacking
- Factory Technical Support
- Part II Installation and SetUp
- A.\) Installation – Keyboard Wedge Interface
- Reset All Defaults – Keyboad Wedge Interface
- Computer Type Selection (for Keyboard Wedge only)
- Intercharacter Delay for Keyboard Wedge interface
- B.\) Installation – RS232 Interface
- Reset All Defaults – RS232
- RS-232C Communication Parameters
- Handshaking Protocol
- Baud Rate
- Data Bits / Stop Bits / Parity
- C.\) Installation – USB Interface
- Reset All Defaults - USB Interface
- Part III Bar Code Menu Functions
- Section A Programming the Scanner
- Symbology Selection
- Symbology Additions
- Setting the Number of Characters to be Scanned
- UPC Settings
- EAN-13 and EAN-8 Settings
- Code 39 Settings
- Codabar Settings
- MSI/Plessey Settings
- Code 128, EAN 128 Settings
- IATA Settings
- Telepen Settings
- Case Conversion
- Setting a Prefix or Suffix
- Prefix Settings
- Suffix Settings
- Direct Input Keyboard Keys
- Direct Input Characters
- Direct Input Control Characters
- Direct Input Code ID/Length
- Read Mode Settings
- Trigger Settings
- Multiple Read Reset Time
- Quiet Zone Settings
- Read Time Settings
- Redundant Decoding Settings
- Positive and Negative Bar Codes
- Buzzer Settings
- Good Read LED
- Diagnostics
Manual No. 25-ULGPMU01-01 Series OPT Handheld
CCD Scanner
Page 31
2of5 Settings (continued)
Code 2of5 is a variable length symbology with an optional check digit and non printable start and stop character.
Supported characters include numeric digits 0 to 9.
The checksum is calculated as the sum modulo 10 of the numerical values of all the data characters. The following
2of5 codes are supported.
Industrial 2of5 (D 2of5) - This symbology encodes a pair of digits in each symbol, the number of digits are
therefore always an even number. Information is carried in the bars and spaces. The start and stop pattern in not
unique inside the code. It is therefore essential to use the fixed length option to prevent partial reads.
Matrix 2of5 - This symbology encodes 1 digit in each character, the number of digits can therefore be an odd or an
even number. Information is carried in the bars and spaces.
String format - Industrial, Interleaved or Matrix 2of5:
leading
zero
data (1 or
more digits)
check
digit
Options for Code 2of5:
* Disable transmission of the check digit
* Enable check digit check
* Selection of the minimum number of data characters
* Disable space check for industrial 2of5
* Transmit S Code as Interleaved 2of5
*
Minimum data characters - Code 2of5 are checked for a minimum of 1, 3 or 5 characters as set by the user. If the
number of characters in the label is less than the number set, the label will be rejected. If the fixed length option is
used for a Code 2of5 type label, then such label will also be checked for fixed length.
Intercharacter gap check - This option enables the reading of Industrial 2of5 labels with a large or irregular
spacing.