Scanner User Manual
Table Of Contents
- April 2002
- Part I
- General Information
- Unpacking
- Factory Technical Support
- Part II Installation and SetUp
- A.\) Installation – Keyboard Wedge Interface
- Reset All Defaults – Keyboad Wedge Interface
- Computer Type Selection (for Keyboard Wedge only)
- Intercharacter Delay for Keyboard Wedge interface
- B.\) Installation – RS232 Interface
- Reset All Defaults – RS232
- RS-232C Communication Parameters
- Handshaking Protocol
- Baud Rate
- Data Bits / Stop Bits / Parity
- C.\) Installation – USB Interface
- Reset All Defaults - USB Interface
- Part III Bar Code Menu Functions
- Section A Programming the Scanner
- Symbology Selection
- Symbology Additions
- Setting the Number of Characters to be Scanned
- UPC Settings
- EAN-13 and EAN-8 Settings
- Code 39 Settings
- Codabar Settings
- MSI/Plessey Settings
- Code 128, EAN 128 Settings
- IATA Settings
- Telepen Settings
- Case Conversion
- Setting a Prefix or Suffix
- Prefix Settings
- Suffix Settings
- Direct Input Keyboard Keys
- Direct Input Characters
- Direct Input Control Characters
- Direct Input Code ID/Length
- Read Mode Settings
- Trigger Settings
- Multiple Read Reset Time
- Quiet Zone Settings
- Read Time Settings
- Redundant Decoding Settings
- Positive and Negative Bar Codes
- Buzzer Settings
- Good Read LED
- Diagnostics
Manual No. 25-ULGPMU01-01 Series OPT Handheld CCD Scanner
Page 3
Table of Contents
PART I CCD Scanning
General Information ...........................................4
Unpacking
Factory Technical Support
Part II Installation and SetUp
A. Installation –Wedge Interface ……………5
Reset all Defaults …………………………………………….6
Computer Type Selection … ............................... 6
InterCharacter Delay ..........................................7
B. Installation – RS232 Interface................ 8
RS-232C Communication Parameters ..................9
Baud Rate..........................................................9
Data Bits / Stop Bits / Parity..............................10
C. Installation – USB Interface...................11
_________________________________________
NOTICE
Opticon has taken every step to ensure that the
information included in this manual is accurate,
however we reserve the right to change any
specification at any time without prior notice.
_________________________________________
Part III Bar Code Menu Functions
Section A Programming the Scanner……………..12
Section B Symbology Selections ..................... 13
Enabling only a single symbology...................... 13
Enabling an addition symbology........................ 13
Setting Options for UPC-A/E ............................. 17
Setting Options for EAN-13 and -8 .................... 20
Code 39 Settings ............................................. 22
Codabar Settings ............................................. 24
2 of 5 Settings................................................. 27
MSI/Plessey Setting ......................................... 29
Code 128 Setting ............................................. 30
IATA Settings .................................................. 31
Section C: Universal Selections
Case Conversion .............................................. 33
Prefix Options.................................................. 34
Suffix Options.................................................. 36
Direct Input - Keyboard Keys............................ 38
Direct Input - Characters ................................ 44
Direct Input - Control Characters ...................... 49
Read Mode Settings ......................................... 52
Trigger Settings ............................................... 53
Beeper Options................................................ 57
Good Read Indicator (LED)............................... 59