Scanner User Manual
Table Of Contents
- April 2002
- Part I
- General Information
- Unpacking
- Factory Technical Support
- Part II Installation and SetUp
- A.\) Installation – Keyboard Wedge Interface
- Reset All Defaults – Keyboad Wedge Interface
- Computer Type Selection (for Keyboard Wedge only)
- Intercharacter Delay for Keyboard Wedge interface
- B.\) Installation – RS232 Interface
- Reset All Defaults – RS232
- RS-232C Communication Parameters
- Handshaking Protocol
- Baud Rate
- Data Bits / Stop Bits / Parity
- C.\) Installation – USB Interface
- Reset All Defaults - USB Interface
- Part III Bar Code Menu Functions
- Section A Programming the Scanner
- Symbology Selection
- Symbology Additions
- Setting the Number of Characters to be Scanned
- UPC Settings
- EAN-13 and EAN-8 Settings
- Code 39 Settings
- Codabar Settings
- MSI/Plessey Settings
- Code 128, EAN 128 Settings
- IATA Settings
- Telepen Settings
- Case Conversion
- Setting a Prefix or Suffix
- Prefix Settings
- Suffix Settings
- Direct Input Keyboard Keys
- Direct Input Characters
- Direct Input Control Characters
- Direct Input Code ID/Length
- Read Mode Settings
- Trigger Settings
- Multiple Read Reset Time
- Quiet Zone Settings
- Read Time Settings
- Redundant Decoding Settings
- Positive and Negative Bar Codes
- Buzzer Settings
- Good Read LED
- Diagnostics
Manual No. 25-ULGPMU01-01 Series OPT Handheld
CCD Scanner
Page 25
Codabar Settings
ZZ
Start/End
Program
Menu
-[[-
F0
Do not
transmit
start/stop
-G1-
%
F1
Transmit
start/stop as
ABCD/TN*E
-G2-
F2
Transmit
start/stop as
abcd/tn*e
-G3-
F3
Transmit
start/stop as
ABCD/ABCD
-G!-
F4
Transmit
start/stop as
abcd/abcd
-G5-
H3
Enable
Codabar,
ABC and CX
-I!-
H4
Enable only
ABC code
-I5-
H5
Enable only
CX code
-I6-
H6
Check CD
-I7-
H7
Do not
check CD
-I8-
%
H8
Transmit
CD
-I9-
%
H9
Do not
transmit CD
-I:/