Scanner User Manual
Table Of Contents
- April 2002
- Part I
- General Information
- Unpacking
- Factory Technical Support
- Part II Installation and SetUp
- A.\) Installation – Keyboard Wedge Interface
- Reset All Defaults – Keyboad Wedge Interface
- Computer Type Selection (for Keyboard Wedge only)
- Intercharacter Delay for Keyboard Wedge interface
- B.\) Installation – RS232 Interface
- Reset All Defaults – RS232
- RS-232C Communication Parameters
- Handshaking Protocol
- Baud Rate
- Data Bits / Stop Bits / Parity
- C.\) Installation – USB Interface
- Reset All Defaults - USB Interface
- Part III Bar Code Menu Functions
- Section A Programming the Scanner
- Symbology Selection
- Symbology Additions
- Setting the Number of Characters to be Scanned
- UPC Settings
- EAN-13 and EAN-8 Settings
- Code 39 Settings
- Codabar Settings
- MSI/Plessey Settings
- Code 128, EAN 128 Settings
- IATA Settings
- Telepen Settings
- Case Conversion
- Setting a Prefix or Suffix
- Prefix Settings
- Suffix Settings
- Direct Input Keyboard Keys
- Direct Input Characters
- Direct Input Control Characters
- Direct Input Code ID/Length
- Read Mode Settings
- Trigger Settings
- Multiple Read Reset Time
- Quiet Zone Settings
- Read Time Settings
- Redundant Decoding Settings
- Positive and Negative Bar Codes
- Buzzer Settings
- Good Read LED
- Diagnostics
Manual No. 25-ULGPMU01-01 Series OPT Handheld
CCD Scanner
Page 21
EAN-13 and EAN-8 Settings
EAN-13 is a fixed length symbology encoding 12 data digits, a check digit and non printable start/stop characters.
Supported characters are numeric digits 0 to 9. The data may be translated into ISBN or ISSN format.
String format:
data
(12 digits)
check
digit
EAN-13 add-on 2/add-on 5 - The EAN-13 symbology as described above can be succeeded by an additional 2 or 5
digit UPC-A code.
String format:
data
(12 digits)
check
digit
add-on
2 or 5
EAN-8 is a fixed length symbology encoding 7 data digits, a check digit and non printable start/stop characters.
Supported characters are numeric digits 0 to 9.
String format:
data
(7 digits)
check
digit
EAN-8 add-on 2/add-on 5 - The EAN-8 symbology as described above can be succeeded by an additional 2 or 5
digit UPC-A code.
String format:
data
(7 digits)
check
digit
add-on
2 or 5
Options for EAN
* Disable transmission of the check digit
* Enable ISBN or ISSN translation
Enable ISBN or ISSN translation - If this option is enabled, an EAN-13 label is verified for the correct format and
transmitted as a 10 digit ISBN number or 8 digit ISSN number.