Scanner User Manual
Table Of Contents
- April 2002
- Part I
- General Information
- Unpacking
- Factory Technical Support
- Part II Installation and SetUp
- A.\) Installation – Keyboard Wedge Interface
- Reset All Defaults – Keyboad Wedge Interface
- Computer Type Selection (for Keyboard Wedge only)
- Intercharacter Delay for Keyboard Wedge interface
- B.\) Installation – RS232 Interface
- Reset All Defaults – RS232
- RS-232C Communication Parameters
- Handshaking Protocol
- Baud Rate
- Data Bits / Stop Bits / Parity
- C.\) Installation – USB Interface
- Reset All Defaults - USB Interface
- Part III Bar Code Menu Functions
- Section A Programming the Scanner
- Symbology Selection
- Symbology Additions
- Setting the Number of Characters to be Scanned
- UPC Settings
- EAN-13 and EAN-8 Settings
- Code 39 Settings
- Codabar Settings
- MSI/Plessey Settings
- Code 128, EAN 128 Settings
- IATA Settings
- Telepen Settings
- Case Conversion
- Setting a Prefix or Suffix
- Prefix Settings
- Suffix Settings
- Direct Input Keyboard Keys
- Direct Input Characters
- Direct Input Control Characters
- Direct Input Code ID/Length
- Read Mode Settings
- Trigger Settings
- Multiple Read Reset Time
- Quiet Zone Settings
- Read Time Settings
- Redundant Decoding Settings
- Positive and Negative Bar Codes
- Buzzer Settings
- Good Read LED
- Diagnostics
Manual No. 25-ULGPMU01-01 Series OPT Handheld
CCD Scanner
Page 18
UPC Settings
Options for UPC-A and UPC-E bar codes.
NOTE: Abbreviations: Xmit = transmit; CD = Check digit; CC = Country code
ZZ
Start/End
Program
Menu
-[[-
E2
UPC-A
as EAN13
w/ CD
(13 digits)
-F3-
E3
UPC-A
w/ CD
(12 digits)
-F!-
%
E4
UPC-A
w/ CD
(12 digits)
-F5-
E5
UPC-A
w/o CD
(11 digits)
-F6-
E6
UPC-E
w/ CC & CD
(8 digits)
-F7-
E7
UPC-E
w/o CC,
w/ CD
(7 digits)
-F8-
%
E8
UPC-E
w/ CC,
w/o CD
(7 digits)
-F9-
E9
UPC-E
w/o CC & CD
(6 digits)
-F:-
6P
Xmit UPC-E
as UPC-A
w/ CD
(8 digits)
-7Q-
6Q
Do not
xmit UPC-E
as UPC-A
w/o CD
(7 digits)
-7R-
%