Scanner User Manual
Table Of Contents
- April 2002
- Part I
- General Information
- Unpacking
- Factory Technical Support
- Part II Installation and SetUp
- A.\) Installation – Keyboard Wedge Interface
- Reset All Defaults – Keyboad Wedge Interface
- Computer Type Selection (for Keyboard Wedge only)
- Intercharacter Delay for Keyboard Wedge interface
- B.\) Installation – RS232 Interface
- Reset All Defaults – RS232
- RS-232C Communication Parameters
- Handshaking Protocol
- Baud Rate
- Data Bits / Stop Bits / Parity
- C.\) Installation – USB Interface
- Reset All Defaults - USB Interface
- Part III Bar Code Menu Functions
- Section A Programming the Scanner
- Symbology Selection
- Symbology Additions
- Setting the Number of Characters to be Scanned
- UPC Settings
- EAN-13 and EAN-8 Settings
- Code 39 Settings
- Codabar Settings
- MSI/Plessey Settings
- Code 128, EAN 128 Settings
- IATA Settings
- Telepen Settings
- Case Conversion
- Setting a Prefix or Suffix
- Prefix Settings
- Suffix Settings
- Direct Input Keyboard Keys
- Direct Input Characters
- Direct Input Control Characters
- Direct Input Code ID/Length
- Read Mode Settings
- Trigger Settings
- Multiple Read Reset Time
- Quiet Zone Settings
- Read Time Settings
- Redundant Decoding Settings
- Positive and Negative Bar Codes
- Buzzer Settings
- Good Read LED
- Diagnostics
Manual No. 25-ULGPMU01-01 Series OPT Handheld
CCD Scanner
Page 11
C.) Installation – USB Interface
Plug the scanner into the USB connector on your host computer. PC must be running Windows 98 or higher or
iMac Rev A or higher. The computer will sense the presence of the scanner and load any required software drivers
automatically.
Reset All Defaults - USB Interface
Our scanners are shipped with factory default settings that represent the settings most commonly used by our
customers. In most applications, the scanner will work right out of the box without any need for additional
programming. At any time you can return the scanner to the factory default settings by scanning the “Reset all
Defaults” programming bar code below.
ZZ
Start
Program
Menu
-[[-
SU
USB
-TV-
ZZ
End
Program Menu
-[[-