User Manual
Table Of Contents
- 1. Abstract
- 2. Overview
- 3. Physical Features
- 4. Environmental Specifications
- 5. Electrical Specifications
- 6. Interface Specifications
- 7. Cables and Connectors
- 8. Labels
- 9. Packaging Specifications
- 10. Regulatory Compliance
- 11. Safety recommendations
- 12. Mechanical Drawings
Opticon
CRD9823-RU
Specifications Manual
8
6.2. Communications Interface
The baud rate can be configured via DIP switches on the bottom of the cradle. The baud
rate can also be configured by using special software on the host.
6.2.1.
Baud rate Configuration using DIP switches
To disable software configuration, set SW4 to OFF.
Baud rate can be configured using SW1–SW3 as listed in the table below.
Baud rate
DIP Switch
SW1 SW2 SW3 SW4
115.2 kbps ON ON ON OFF
57.6 kbps OFF ON ON OFF
38.4 kbps ON OFF ON OFF
19.2 kbps OFF OFF ON OFF
9600 bps ON ON OFF OFF
4800 bps OFF ON OFF OFF
2400 bps ON OFF OFF OFF
1200 bps OFF OFF OFF OFF
Figure 1: DIP switch settings
Remove the cover and change the settings. Put the cover back on when finished.